Pinnacle GlassWork Water Spot Remover PIN-830

Description

Removes water spots and road film without scratching glass!
Over time, water spots and road film build up on the surface of glass reducing visibility and diminishing the efficiency of your car’s windshield wipers.  This can reduce visibility and create a dangerous vision issue when driving in heavy rain, sleet or snow.  Pinnacle GlassWork Water Spot Remover removes water spots and road film quickly and easily by hand or machine.
Normal glass cleaners are great for removing fingerprints, streaks and smears.  However, a layer of oily road film or mineral deposits requires something more aggressive.
Pinnacle GlassWork Water Spot Remover uses glass-safe abrasive technology plus a blend of citrus-based mineral dissolving agents to safely clean and remove road film and water spots off of glass.
Pinnacle GlassWork Water Spot Remover restores a clean and crystal clear glass surface.
After using Pinnacle GlassWork Water Spot Remover,
your glass will be perfectly clear.  You will notice your wipers gliding over the slippery surface, quickly clearing rain, sleet, snow or road spray away from your windshield for safer driving.
Recommendations
Always work on a cool surface in the shade.
Glass should be washed and dried before use.
Hand Application:
Apply a quarter-sized amount of product directly onto a foam or microfiber applicator pad.
Work on a 12” x 12” section of glass.
Using firm pressure, apply Pinnacle GlassWork Water Spot Remover to glass using an overlapping, circular motion.
Thoroughly work the polish in until it starts to turn clear.  When it turns clear, it is ready to be wiped off.
After working one section, immediately wipe off any excess residue using a clean, microfiber towel.
Repeat with each section until the entire area is completed.
Machine Application:
Pinnacle GlassWork Water Spot Remover can be applied with any type of machine polisher.  Begin by taping-off and covering up any adjacent painted panels to avoid splatter.
Apply about a quarter sized amount of product and work over a section of glass at a medium to high speed setting.  We recommend using a Lake Country light-cutting or polishing foam pad.
Use overlapping passes.  Work product in until it starts to turn clear.  If there are any remaining water spots, add more product and continue to polish.
Wipe residue off immediately with microfiber towel and move to a new section of glass.
Can be applied by hand...
Or machine...
16 oz.