Power Probe III PP3CSRED Automotive Circuit Tester with a Lumintrail Light

Description

The original Power Probe 3 uses a 20ft cable which attaches to the vehicle’s battery, allowing the user to perform an electrical test anywhere in, or around the vehicle. The PP3 is a Voltmeter and Continuity Tester, with Audible & Visual indicators along with two LED headlights to light up your work area. This circuit tester also supplies Battery Voltage or Ground to activate components. This powerful time-saver tool is perfect for every level of technician.
The Power Probe 3 is a Digital Voltmeter designed to work on 12-24 Volt sources, with the ability to apply Power and Ground. Using an Auxiliary Ground cable, the user can simultaneously supply Battery Voltage, and ground to test components or to simply test for continuity. The PP3 is protected by an 8 Amp Circuit Breaker.
Voltage & Polarity testing
Continuity testing
Activating components out of the vehicle’s electrical system
Activating electrical components in the Vehicle
Activating electrical components with ground
Testing trailer lights and connections
Checking for bad ground contacts
Red/Green Indicator & Audio Tone
SPECIFICATIONS
DC 0 to +70V +1 Digit
P-P 0 to +70V,
The frequency response of tone pass through
10Hz to greater than 10 kHz,
PP Display
15 Hz Square Wave
35 Hz Sine Wave,
Power Probe Mode – Continuity to ground
First level – Display is enabled less than 20 K Ω
The second level – Green LED is enabled less than 600 Ω,
– & +Peak Detector Response
Single event capture less than 200ms pulse width
Repetitive events less than 1ms pulse width,
Peak to Peak Mode
0 to + 70 + 1 Digit
4Hz to over 500kHz Square Wave input
4Hz to over 250kHz Sine Wave input
The threshold for PPAC/Audible passthrough
Circuit Breaker 8 amp thermal response – Manual reset
The PP3CS Includes:
Probe Tip
Battery Clip-Set (for connecting to vehicle battery)